Set-Up Instructions - Campbell Hausfeld CL252100AV Mode D'emploi

uctions
ve these instructions. Read carefully before attempting to assemble, install,
n the product described. Protect yourself and others by observing all safety
e to comply with instructions could result in personal injury and/or property
structions for future reference.
Safety
on (Continued)
dust when
drill or grind
as wood,
ncrete, cement, or
This dust often contains
wn to cause cancer, birth
er reproductive harm.
gear.
FETY
a part of a high pressure
following safety
st be followed at all times
other existing safety rules.
anuals included
duct carefully.
MANUAL
ly familiar with
and the proper
quipment.
ns well acquainted with
of safe operation should
o use the air tool.
maximum
ure of the air
he air tool COULD explode
ath or serious personal
eed any pressure rating
ponent in the system.
perating pressure of 90
ured at the tool inlet while
nning. The pressure drop
e compressor and tool
compensated for at the
www.campbellhausfeld.com
Release ALL pressure from the
system before attempting to
install, service, relocate or perform any
maintenance.
4. Disconnect air tool from air supply
when not in use and before changing
tools, attachments or performing
service.
Safety glasses and ear
protection MUST be worn
during operation.
5. Do NOT wear loose fitting clothing,
scarves, neck ties or jewelry when
operating any tool. Loose clothing
or jewelry may become caught in
moving parts and result in serious
personal injury.
6. Do NOT depress trigger when
connecting air supply hose to tool.
7. Do NOT put hands near or under
moving parts.
Excessive exposure
to vibration,
working in awkward positions and
repetitive work motions can cause injury
to hands and arms. Stop using any tool
if discomfort, numbness, tingling or pain
occur and consult a physician.
8. Check air hoses for weak or worn
condition before each use. Make sure
ALL connections are secure.
9. Protect air lines from damage or
puncture. Do NOT carry tool by air
hose.
10. NEVER trigger the tool when
not applied to a work object.
Attachments MUST be securely
attached. Loose attachments can
cause serious injury.
11. ALWAYS use attachments designed
for use with air powered tools.
Do NOT use damaged or worn
attachments.
12. Keep ALL nuts, bolts and screws
tight and ensure equipment is in safe
working condition.
13. ALWAYS secure workpiece in a vise
or clamp. Do not place hands on the
back cylinder when operating the
tool.
14. NEVER point an air tool at oneself
or any other person. Serious injury
COULD occur.
15. ALWAYS work in a well ventilated
area and wear OSHA approved dust
mask.
16. Do not use a cut-off disc mandrel on
this tool.
Figure 1
www.campbellhausfeld.com
CL252100AV,
Operation

SET-UP INSTRUCTIONS

Air tools require a supply o
at 90 PSI (6.2 bar). An air s
with filter, regulator, and lu
as shown in Figure 1 shou
Campbell Hausfeld FRL m
(3/8 inch) or PA2114 (1/2 i
recommended.
Water in the air supply can
tool. Drain condensate fro
tank and filter daily.
All hoses and fittings mus
size and tightly fastened. R
for minimum sizes.
Tool Air Consumption
Less than 9 SCFM @ 100% usag
9 to 34 SCFM @ 100% usage
Greater than 34 SCFM @ 100%
Chart 1 - Suggested minimum h
use based on 50 ft length hose
SCFM rating of tool. The use of
hose may require a larger diame
used.
Option 1: Individual components
Filter Regulator Lubricator
Option 2: 3 piece combo
Filter, Regulator, and Lubricator