Uberhaus 780-0384 Guide De L'utilisateur page 20

TROUBLESHOOTING
Problems
Low heat generated with knob
in "HIGH" position.
Check for proper burner flame characteristics. Burner flames should be blue and stable with no yellow
tips, excessive noise, or lifting as shown in Fig. 13. The following steps should be followed for correcting
the flame characteristics:
1. Turn the control knobs and propane Cylinder valves "OFF."
2. Allow the grill and burners to cool.
3. If the flame is yellow (not enough air), turn the adjustment screw found at the front of the burner
counterclockwise.
4. If the flame is noisy or lifts away from the burner (too much air), turn the adjustment screw clockwise.
If these adjustments do not correct the problem, contact customer service at 1-866-206-0888
Fig. 13
Possible Solutions
1. Make certain the problem is isolated to only one burner. If it
appears so, clean the orifice and burner, clearing ports of any
obstruction.
2. Check for a bent or kinked fuel hose.
3. Make sure the air shutter is properly adjusted.
4. Check for proper gas supply and pressure.
5. Pre-heat the grill for a full 15 minutes.
6. Check if propane cylinder is empty.
20