Continuous Measurement; Single Distance Measurement; Area Measurement - METRICA 61130 Mode D'emploi

REFERENCE POINT
Press key to change the reference point. There are four
reference points: top, screw, bottom and the end piece.
SELF-CALIBRATION
This function can keep the precision of the device.
Power off; press the button
Release the button
and a figure under it are shown on the screen. The user can
adjust the figure with the buttons
accuracy of the device. Adjusting range: -9 to 9mm. Then press
for a long time to save the calibration result.
The setting remains also after shutting off the instrument.

SINGLE DISTANCE MEASUREMENT

Turn the laser beam on by pressing of the button
14
and simultaneously.
, then release button
or according to the
under measuring mode; Press the button
measurement of length, then the measured results displayed in
the major display area.
Press

CONTINUOUS MEASUREMENT

Press and hold the
into the continuous measuring mode. Maximum and Minimum
values are shown on the LCD display as well as the instant me-
asurement. Press the
measuring mode.
Press

AREA MEASUREMENT

Press button
until "CAL"
with one side blinking.
Follow display instructions for area measuring
- Press
- Press
the result in the major display area.
- Press
necessary.
i shortly
to cancel the results.
i button under measuring mode to enter
button shortly to exit the continuous
to cancel the results.
, is shown on the display: a rectangle
once for length.
again for width. The device calculates and shows
to clear off the result and to measuring again if
i again for single