Putting Into Operation - Binzel Abicor ABITIG Little Mode D'emploi

®
ABITIG Little

4 Putting into operation

DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Close off the gas supply.
• Close off the coolant supply.
• Disconnect all electrical connections.
DANGER
Risk of injury and device damage when handled by unauthorized persons
Improper repair work and modifications to the product may lead to serious injuries and
damage to the device. The product warranty will be rendered invalid if work is carried out on
the product by unauthorized persons.
• Only qualified personnel are permitted to perform work on the device or system.
NOTICE
• Note of the following instructions:
 3.1 Technical Data on page EN-5
4.1 Equipping the torch
CAUTION
Risk of injury
Puncture or cut-in wounds may be caused by the wire electrode.
• Keep your hands out of the danger zone.
• Wear the correct protective gloves.
Equip the torch neck according to one of the following figures:
Step 2 is omitted for the torches ABITIG
BAL.0186 • 2019-06-19
®
Little 24G, 24W.
4 Putting into operation
EN - 7