Dörr VL-26 RGB Notice D'utilisation page 11

04 | MOUNTING
1. Mount the ball head (04) on the table tripod (06) by screwing the ¼" screw (06a) into the ¼" tripod mount (04b) of the ball head.
2. Mount the LED ring light (01) on the ball head (04) by screwing the ¼" screw (04a) into the ¼" tripod mount (01b) of the LED ring
light.
3. Loosen/fix the locking screw (04c) on the ball head to tilt or turn the LED ring light (01).
4. Mount the smartphone holder (05) on the LED ring light (01) by screwing the ¼" screw (05b) at the bottom of the gooseneck
(05a) into the ¼" connection (01a) of the LED ring light.
5. Spread the clamps of the smartphone holder (05) apart, insert your smartphone and carefully release the clamps to hold the
smartphone in place.
6. Bring your smartphone into the desired position by bending the gooseneck (05a).
05 | OPERATION
1. Connect the USB-A plug (02a) to the USB socket of a PC/Notebook. If the connection is correct, the LED indicator (03d) lights up
blue.
2. To switch on the ring light, press the On/Off button (03c) at the control unit (03).
05.1 White light mode
Ⓜ
Press the button (03f) to enter the white light mode. Press the button
modes:
·
Warm light with a colour temperature of approx. 3000 K
·
Mixed light with a colour temperature of approx. 4500 K
·
Cold light with a colour temperature of approx. 6000 K
Press the button ∨ "Down" (03b) to reduce the brightness in 12 steps.
Press the button ∧ „Up" (03a) to increase the brightness in 12 steps.
05.2 RGB colour and effect mode
various colour, fade, and flashing effects. In all effect modes the buttons ∨ "Down" (03b) and ∧ „Up" (03a) can be pressed to adjust
(03e) to enter the RGB colour and effect mode. Press the button
Press the button RGB
either the playback speed or the brightness (see table on next page).
11
Ⓜ
(03f) repeatedly to select one of the following light
(03e) repeatedly to browse through the
RGB
doerr-foto.de