Replacing The Chargepak F1 - PURE Jongo S340B Mode D'emploi

Replacing the ChargePAK F1

1. Switch Jongo off and disconnect from the mains power supply.
2. Turn Jongo upside down and use a screwdriver to open the
battery compartment on the base of Jongo.
3. Replace ChargePAK so that the Pure label is facing the battery
compartment lid and the ChargePAK contacts line up with the
three terminals in the battery compartment.
4. Replace the battery cover and secure with the screw, ensuring
that the screw is not over-tightened, and connect your product
to a power supply.
5. ChargePAK will begin charging.
Note: When charging your ChargePAK for the first time or
after an extended period of inactivity it is recommended that
it is charged for around 24 hours to ensure full battery power.
If ChargePAK is completely flat, there may be a slight delay
before the battery charging indicator is displayed.
Note: It is normal for your ChargePAK to get warm, especially
during charging. Your ChargePAK will give years of trouble-free use
under normal circumstances, but like all rechargeable batteries its
efficiency will gradually reduce with age.
Important: Jongo can only be powered with a Pure ChargePAK F1
and is not compatible with any other batteries, either disposable or
rechargeable, or any other ChargePAK model.
EN
19