Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TE_AUTHENTIQUE_1520008720.qxp_Mise en page 1 11/06/2019 09:27 Page5
Instructions for use
Opening
Turn the tightening button counter-clockwise to lower the clamp.
Lift the lid to unlock it.
Slide it horizontally
Closing
Slide the lid horizontally and fit it onto the edge of your pressure cooker,
ensuring that it correctly covers the body of the pressure cooker.
Turn the tightening button clockwise until the clamp comes into contact with
the pressure cooker's clamp hooks
To ensure that the lid is locked, turn the tightening button again (at least
three full turns).

First use

Turn your pressure cooker over to assemble the handles. Position them
correctly, insert the screw and tighten
After a few days of use, tighten the screws again.
Place valve on the steam release rod and press hard - Fig. 6
Depending on model:
Position the tripod* (M) and the basket* (G) on the
base of the pan.
Clip the tripod* (N) onto the basket* (G), then place
in the bottom of the pan.
Fill the pan (L) with water up to 2/3 of its capacity.
Close the pressure cooker.
Place your pressure cooker on a heat source then
set to maximum power.
When steam begins to be released by the valve,
turn down the heat source and set a timer for 20
min.- Fig. 7
After 20 min., turn off the heat source.
Remove the valve taking care that the steam does not scald you.
When steam stops being released from the operating valve, open the
pressure cooker
Rinse the pressure cooker with water and dry it.
Use a scouring pad with a little diluted vinegar to remove any traces of
limescale.
*depending on model
- Fig
1.
- Fig.
- Fig. 1
2.
- Fig. 5
EN
5

Publicité

Table des Matières
loading

Table des Matières