Table des Matières
Publicité
Step 14
NOTE: There are no pre-drilled holes in the 427013 or
å
427015 for attaching the HUTCH. You will need to drill
1/8" wide, 1" deep holes through the open holes in the
BRACKET CONNECTORS (81G).
Fasten the HUTCH to the unit you have drilled the holes
å
into. Use four SILVER 1" LARGE HEAD SCREWS (102S)
through the BRACKET CONNECTORS and into the unit.
Mark and drill 1/8" holes
through the holes in the
BRACKET CONNECTORS.
SILVER 1" LARGE HEAD SCREW
(4 used in this step)
www.sauder.com/service
102S
81G
427017
Page 19
Publicité
Table des Matières
