Table des Matières
Publicité
Step 10
Carefully turn your unit over on it's back.
å
Fasten four METAL BRACKETS (4G) to the TOP
å
MOLDING (C). Use four BLACK 9/16" LARGE
HEAD SCREWS (1S).
Fasten the TOP MOLDING (C) to the TOP (H). Use four
å
BLACK 9/16" LARGE HEAD SCREWS (1S) through the
METAL BRACKETS and into the TOP.
NOTE: You should start each SCREW a few turns before
å
completely tightening any of them.
C
H
www.sauder.com/service
4G
427017
BLACK 9/16" LARGE HEAD SCREW
(8 used in this step)
C
1S
Page 15
Publicité
Table des Matières
