Princess 352718 Mode D'emploi page 9

Sleep operation
• In cooling mode, press the "Sleep" button to set the temperature.
The set temperature is increased by 1 degree within one hour to
a maximum of 2 degrees after 2 hours.
• Press "Sleep" button to cancel the operation.
Drainage
• After a lengthy operation and before storage, you will need to
drain the water that has been collected. Please prepare a
suitable location or tray to collect the water and remove the
rubber stop from the drainage hole at the bottom of the unit. The
water will then begin to drain. After this has stopped, you can
insert the drain stop.
Internal Tank Water Full Alarm Function
• The inner water tank in the air-conditioner has one water level
safety switch that controls the water level. When the water level
reaches an anticipated height, the water full indicator lamp lights
up. Follow previous steps to drain the water.
INSTALLATION
• The air-conditioner should be installed on a flat and stable
surface. Do not block the air outlet and allow at least 30cm
around the unit.
• Socket wiring should be in accordance with the local electric
safety requirements.
Exhaust Hose Installation
• Twist both ends of the hot-air exhaust hose(9) into the hose
connector window end(8) and the hose connector air conditioner
end(10).
• Insert the hose connector air conditioned end(10) into the
openings at the back of the air conditioner.
• Fix the hose connector window end(8) to the nearest windowsill.
Universal Window Kit Installation
• Clean the window and window frame with soap or detergent and
make sure the entire window frame is dust and grease free.
• Cut the Velcro to the dimensions of the window with scissors.
• Attach the Velcro around the entire window. Note: don't stick the
Velcro onto the glass.
• Attach the cloth to the Velcro tape. Start with the narrow part and
work from the center towards the rest of the Velcro tape, which is
attached on the window frame and around the window.
Instruction manual
EN
9