Stadler Form Atlas Mode D'emploi page 12

• Clean the bottle, the Bottle Adapter, Mist Outlet. Remove scales and re-
sidual dirt by de-calcification agent.
• The surface of Oscilliator can be cleaned with the Brush (12).
• Note: this product is NOT dishwasher save
• Rinse all the parts with fresh clean water. Note: be careful not to let
water running into the Base Unit.
• Dry all parts with soft cloth.
iMPORtANt
Do not use cleaning agents or other scouring agents to clean the unit.
Do not use any metal or hard objects to clean the Oscillator.
tROubLe-shOOtiNG
Problem Possible cause
Unit switched Adaptor not properly
on, but no mist connected with the unit
coming out and the main supply
solution
Check if the Adaptors
Plug is properly in-
serted into main supply
socket and with the
Adaptor socket on the
Main Base
Problem Possible cause
Unit gives only Too much scale or
small amount water level is too high
of mist coming
from the unit
Unit gives bad Reservoir is dirty or not
smell properly cleaned
RePAiRs / DisPOsAL
• Repairs to all electric devices (including replacement of the power cable)
may only be performed by instructed experts. Carrying out inappropriate
repairs voids the warranty and no liability shall be accepted.
• If the power cable has become damaged, it must be replaced by the
manufacturer, his official service partner or a qualified person, in order
for further damage to be avoided.
• Never operate the device if the cable or the plug is damaged, after the de-
vice has malfunctioned, if it has been dropped or if it has been damaged in
any other way (i.e. with cracks or breakages to the housing).
• Do not use any sharp, abrasive objects or corrosive chemicals.
• Disable devices that are to be discarded immediately (by cutting off the
power cable) and dispose of them at an appropriate waste collection cen-
tre.
solution
Clean the unit and
remove the scale, or
take out some water
from Reservoir
Clean the unit, and refill
with fresh water