Technical Data - Gardeo GBV2600SWB Traduction Des Instructions D'origine

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Description
1.
Overload protector
2.
On/off switch
3.
Reversing switch
4.
Feeding tunnel
5.
Electric plug
6.
Adjuster
7.
Collection box
8.
Base frame
9.
Front wheel
10. wheel
11. Safety switch

Technical data

Model:
Mains voltage / frequency:
Rated power:
Operating mode:
Rated power (S1):
No-load speed:
Branch diameter:
Weight:
The S 6 duty cycle (40 %) indicates a load profile of 4
min. running under load and 6 min. of idle time. The
maximum branch diameter depends on the hardness
of the wood.
Noise emission values measured according to relevant
standard.
Acoustic pressure level
Acoustic power level
K=0.4 dB(A)
Guaranteed sound power level Lwa 89dB(A)
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
(Fig. 1)
GBV2600SWB
230 V ~ 50 Hz
2.600 W
S 6
2000 W
40 min
Max. 40 mm
28.0 kg
LpA 79.8 dB(A) K=3 dB(A)
LwA 88.57 dB(A)
ATTENTION !
must be worn.
Warning !
1.
Do not allow children to operate this equipment.
2.
Do not operate this equipment in the vicinity of
bystanders.
3.
Wear ear protection and safety glasses at all
times while operating this machine.
4.
Avoid wearing clothing that is loose fitting or that
has hanging cords or ties.
5.
Only operate the machine in an open space
(e.g. not close to a wall or to any other fixed
object) and on a firm, level surface.
6.
Do not operate the machine on a paved or
gravel surface where ejected material could
cause injuries.
7.
Before starting the machine, check that all
screws, nuts, bolts, and other fasteners are
properly secured and that guards and screens
are in place. Replace damaged or unreadable
labels.
-1
Assembling
Scope of delivery
1x Instruction manual
1x Spanner
1x Silent shredder
1x Collection box
1x Base frame
2x Wheel set
2x front wheel set
1x Small parts bag
1x Adjuster
8. Take all parts out of the package. Be sure four
protruding supports in the bottom of the motor unit pass
through four notches in the upper face of the base frame.
(Fig. 3)
9. Slide the collection box out of the base frame. (Fig. 4)
10. Fit the front wheel sets to the base frame with the aid
of two screws. (Fig. 5)
11. Use the spanner to mount wheels to the base fame
using two wheel shafts, two grommets, two spring
grommets and two screws. Assemble cap by pushing in
on by hand. (Fig. 6)
12. Slide the collection box back to the base frame.
Ensure that the collection box runs above the guide rails.
(Fig. 7)
13. Stand and put hands in position as shown in Fig. 8.
Lay the motor unit on the base frame by placing four
protruding supports (Fig. 8/Item B) of the motor unit on
the slots (Fig. 8-1/Item A) of the base frame.
14. Fix the location plate to the base frame with two
screws. (Fig. 9)
15. Lock the collection box with safety switch in position
by pushing upwards. (Fig. 10-1)
Preparation
(Fig. 2)

Publicité

Table des Matières
loading

Table des Matières