Gardeo GBV2600SWB Traduction Des Instructions D'origine page 23

Before starting the machine, check that all
screws, nuts, bolts and other fasteners are
properly secured and that guards and
screens are in place. Replace damaged or
unreadable warning and operating labels.
Before starting the machine, make certain
that the chute assembly is empty.
Keep your face and body away from the
chute assembly.
Do not allow hands or any other part of the
body or clothing inside the chute assembly,
discharge chute or near any moving part.
Keep proper balance and footing at all
times. Do not overreach. Never stand at a
higher level than the base of the machine
when feeding material.
Always stand clear of the discharge zone
when operating the machine.
When feeding material into the machine be
extremely careful that pieces of metal,
rocks, bottles, cans or other foreign objects
are not included.
If the cutting mechanism strikes any foreign
object or if the machine should start
making any unusual noise or vibration, immediately
switch off and allow the cutter to stop. Remove the plug
from the mains supply and take the following steps:
– Inspect for damage.
– Replace or repair any damaged parts.
– Check for and tighten any loose parts.
Do not attempt to repair the machine unless
you are qualified to do so.
Do not allow processed material to build
up in the discharge zone; this may prevent
proper discharge which can result in kickback
of material through the chute assembly.
If the machine becomes clogged, switch
off and allow the cutter to stop. Remove
the plug from the mains supply before clearing debris.
Check if guards and protective devices are
undamaged and properly mounted. Before
using, carry out possibly necessary maintenance
and repairs.
Do not tamper with the motor speed control
settings. Contact a GARDEO approved
service agent if a problem exists.
Keep the motor cooling vents clean of debris
and other accumulations to prevent
damage to the motor or possible fire.
Never pick up or carry the machine while
the motor is running.
Switch off, allow the cutter to stop and remove
the plug from the mains supply whenever you leave the
work area.
Do not tilt the machine while it is running.
Do not expose the machine to rain. Only
store the machine in a dry place.
Maintenance and Storage
When the machine is stopped for servicing,
inspection, or storage, or to change an accessory,
switch off and remove the plug from the mains supply
and allow the machine to cool. Make sure that all moving
parts have come to a complete stop before
making any inspections, adjustments, etc.
Maintain the machine with care and keep it clean.
Examine the machine and replace worn or
damaged parts for safety.
Ensure replacement parts fitted are GARDEO
approved.
If an extension cord is used it shall not be
of lighter grade than the supply cord already
fitted to the machine.
Check the supply and any extension cord
regularly for damage or signs of ageing. Do
not use the machine, if the cords are damaged.
When servicing the cutter be aware that,
even though the motor will not start due to
the interlock feature of the guard, the cutter
can still be moved if the motor is turned
by hand.
Never attempt to override the interlock
feature of the guard.