Safety Instructions - Hama C2 Mode D'emploi

G Operating instruction
Thank you for choosing this Hama product!
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference.
1. Explanation of warning symbols and notes
Risk of electric shock
This symbol indicates a risk of electric shock from
touching uninsulated product parts that may carry
hazardous voltage.
Warning
This symbol is used to indicate safety instructions
or to draw your attention to specific hazards
and risks.
Note
This symbol is used to indicate additional
information or important notes.
2. Package contents
• charger
• these operating instructions

3. Safety instructions

• Protect the product from dirt, moisture and
overheating and use it in dry rooms only.
• Do not drop the product and do not expose it to
any major shocks.
• Do not operate the product outside the power
limits specified in the technical data.
• Do not modify the device in any way. Doing so
voids the warranty.
• Do not continue to operate the product if it is
visibly damaged.
• Use the product only for the intended purpose.
• As with all electrical products, this device should
be kept out of the reach of children.
• Do not use the product in the immediate vicinity of
heaters, other heat sources or in direct sunlight.
• Route all cables so there is no risk of tripping.
• Do not bend or crush the cable.
• Always pull directly on the plug when
disconnecting the cable, never on the cable itself.
• Dispose of packaging material immediately in
accordance with the locally applicable regulations.
• The product is intended only for use inside
buildings.
• Only use the article under moderate climatic
conditions.
2
• Do not use the product in areas in which electronic
products are not permitted.
• Do not use the product in a damp environment
and avoid splashing water.
Risk of electric shock
• Do not open the device or continue to operate
it if it becomes damaged.
• Do not use the product if the
AC adapter, the adapter cable or the mains
cable are damaged.
• Do not attempt to service or repair the product
yourself. Leave any and all service work to
qualified experts.
4. Operation
Note - mains voltage 100 - 240 V
The charger is suitable for mains voltages of
100 - 240 V and therefore can be used worldwide.
Please note that a country-specific adapter may
be necessary.
Warning - connecting devices
• Before connecting a device, check whether it
can be adequately supplied with the charger's
current capacity.
• Ensure that the total power of all connected
terminal devices does not exceed 65W (USB-C
45W + USB-A 18W).
• Note the instructions in your device's operating
manual.
Note - Power Delivery / QC 3.0, 2.0
• Plug & GO: no additional software required,
simply plug in and start:
Thanks to Power Delivery / QC 3.0, 2.0, the
voltage and power are adjusted automatically.
• Be aware that, for efficient and optimised
charging, your terminal device must support the
PD (Power Delivery) / QC 3.0, 2.0 function.
• If you have a large number of PD/QC-enabled
devices with different firmware updates, it may
be that the function is not fully supported.