morse AHT 20 Manuel D'instructions page 23

Only qualified personnel should perform troubleshooting and or maintenance operations.
Prior to performing any maintenance or service, be sure that:
• no part of the machine is powered and that it cannot be connected to the mains supply.
• no part of the machine is under pressure and that it cannot be connected to the compressed
air system.
• Maintenance personnel have read and understand the safety and operation instructions in
this manual.
Recommended maintenance: 1 x per year
ATTENTION! Before maintenance or repair, make sure the BEKOMAT is not pressurised.
ATTENTION! Before installation, maintenance or repair, make sure the BEKOMAT is in a powerless state.
Before work, disconnect from power supply.
MAINTENANCE BEKOMAT
BEKOMAT REPLACEMENT PARTS
Description
Service Unit
Set of seals
5.17 MAINTENANCE BEKOMAT
Remove Control Unit (1) by pressing the snap-fit (2).
Disconnect BEKOMAT from the condensate discharge (3).
Disconnect Service-Unit (4) from condensate inlet.
Check if new Service-Unit (4) is correct and suitable for the
control unit (1) (type description, color of snap-fit).
Reassemble the BEKOMAT with the new Service-Unit (4) in
reverse order.
BEKOMAT 31
AHT 20-100
XE KA31 101
XE KA31 002
GB
BEKOMAT 32
AHT 150-350
XE KA32 101
XE KA32 002