Attaching The Anti-Tip-Brackets - Bosch B30BB830SS Notice De Montage

1.

Attaching the anti-tip-brackets

,
WARNING:
Risk of injury and damage!
Assure that there are no electrical wires or
plumbing in the area which the screws could
penetrate.
,
CAUTION:
Risk of injury! Always wear safety glasses and
other necessary protective devices or apparel
when installing or working with dowels.
Note:
2 anti-tip-brackets are required for the appliance.

The supplied set contains fastening screws for

various applications. Select the fastening screws
according to the local conditions.
The anti-tip-brackets (a) must overlap a minimum of
1
2 / " (54 mm) over the appliance to secure
8
the appliance.
If this minimum length cannot be observed for structural
conditions it is possible to do this by fastening
a spacer (b) behind the anti-tip angle, e.g. a sufficiently
dimensioned wood board.
The length of the plank should correspond to the width
of the installation niche!
1. Specify the attachment points of the anti-tip-brackets
according to the section on "Installation
dimensions".
2. Attach the anti-tip-brackets completely.
Be sure screws hold tight.
Important notes for fastening with dowels and screws:
Not recommended for use in light-weight masonry
material such as cinder block.
Not recommended for use in new concrete which has not
had time to cure.
13