Beem SELECTION FRESH-AROMA-PERFECT Superior Mode D'emploi page 41

35
Troubleshooting
If the device does not work properly, check whether you are able to rectify a problem yourself. If the
problem cannot be solved with the steps that are listed, contact our customer service department.
Do not attempt to repair an electrical device yourself!
Problem
Nothing is shown on
the display (15).
The fuse in the fuse box
is triggered.
Water runs out of the
device.
The coffee runs very
slowly into the jug.
The coffee is too weak /
too strong.
A large amount of
steam is produced in
the brewing process.
During use, an
unpleasant smell is
detected.
03201_DE-EN-FR-ES-IT_A5_V2.indb 35 03201_DE-EN-FR-ES-IT_A5_V2.indb 35
Possible cause
The mains plug is not inserted
correctly in the socket.
The plug socket is defective.
There is no mains voltage.
The display is defective.
Too many devices connected to
the same circuit.
There is too much water in the
water tank (6).
The drip stop is blocked.
The device is furred up.
The grinding fi neness and the
coffee strength are not ideal for
the type of coffee.
The device is furred up.
Is the device being used for the
fi rst time?
Has the device just been
descaled?
Fix
Insert the mains plug into a plug
socket.
Try another plug socket.
Check the fuse of the mains
connection.
Contact our customer service
department.
Reduce the number of devices in
the circuit.
Do not overfi ll the water tank!
Clean the fi lter insert (9) with
drip protection.
Descale the device (see the
"Cleaning and Care" chapter –
"Descaling").
Vary the grinding fi neness and
coffee strength to fi nd the ideal
settings for this type of coffee.
Descale the device (see the
"Cleaning and Care" chapter –
"Descaling").
A smell often develops when
new devices are fi rst used. The
smell should disappear once the
device has been used several
times.
Rinse out the device with clear
water.
31.01.2019 11:57:04 31.01.2019 11:57:04
EN