Beem SELECTION FRESH-AROMA-PERFECT Superior Mode D'emploi page 40

EN
Descaling
Limescale deposits have an adverse effect not only on the quality of the coffee and the water, but
they also cause power losses and shorten the lifespan of the device. The thicker a limescale layer is,
the more diffi cult it is to remove.
We therefore recommend regularly removing limescale deposits with a descaling agent in accord-
ance with the water quality in your area and how often the device is used (approx. every 2 – 6
weeks).
The fi rst indications that descaling is required are a large amount of steam being produced and
slower brewing of the coffee.
For descaling we recommend the BEEM premium descaler concentrate. The effi cient, food-safe and
environmentally friendly BEEM premium descaler concentrate is available from selected specialist
stockists, via our website www.beem.de or from our customer service department on request.
Descaling with the BEEM Premium Descaler Concentrate
1. Fill the water tank (6) up to the MAX marking with a concentrate/water solution of no more
than 1:20 (one part concentrate to 20 parts water).
2. Use the button
3. Press the button
4. Let the remaining descaling solution in the water tank take effect for a little while.
5. Use the button
6. Press the button
through.
7. Then rinse the device at least twice by allowing complete tankfuls (12 cups) of clear water to
run through. The device is now descaled and ready to be used again.
Storage
Disconnect the device from the mains power when you are not going to use it for a prolonged
period. Clean the device again if necessary (see the "Cleaning and Care" chapter) and let it dry
completely.
Store the device and all accessories in a dry, clean, frost-free place that is protected from direct
sunlight and is out of the reach of children and animals.
03201_DE-EN-FR-ES-IT_A5_V2.indb 34 03201_DE-EN-FR-ES-IT_A5_V2.indb 34
(19) to set the number of cups to 2.
(16) to switch on the device. Allow the two cups to run through.
to set the number of cups to 10.
to switch on the device and allow the rest of the solution to run
34
31.01.2019 11:57:03 31.01.2019 11:57:03