Skil RAS900 Guide D'utilisation page 21

Installing the quick-clamp
mounting plate and router to the
router table (Figs. 8–11 and
Detail 11)
WARNING
router is securely clamped in the router
table base. While working, periodically
check the router base fasteners clamping
tightness. Router motor vibration can loosen
fasteners during use, causing the router
to fall from the table.
1. Make sure the table (A) is upright and on its
legs (8 and 10) (Fig. 8).
2. Check the clamp handle to make sure it is
open and released (Fig. 9).
3. Position the router mounting plate (4) on the
router so the angled tabs on the mounting
plate are facing down and towards the
router (Fig. 10).
4. While supporting the router, slide the two
angled tabs on the mounting plate into the left
tabs on the base plate. Rotate the router and
the mounting plate up until the mounting plate
is flush against the base plate; then secure the
mounting plate by pushing the clamp handle
towards the router. The latch spring will snap
in place to lock when the clamp handle is
locked (Fig. 11 and Detail 11).
NOTE: Mounting plate must be mounted so no
router parts interfere with the table or the router
mounting mechanism.
DETAIL 11
Latch
Spring
Before using the router
table, verify that the
Closed
Clamp
Handle
Fig. 8
Fig. 9
Opened
Clamp
Handle
Fig. 10
Angled
Tabs
Fig. 11
A
Insert
Tabs
B
Rotate
Router Up
A
10
8
4
Base Plate
Push Clamp
Handle Towards
Routers
C
21