Royal Catering RCES 580H Manuel D'utilisation page 7

TIMER FUNTION
After plugging in, the green lamp lights up. Then turn on the timer and the thermostat,
in which the yellow lamp light up, and the heating element begins to work.
WARNING
This product is commercial machine which should be operated under training!
Do not shake and slope while using. Do not remodel. Dismantling and remodeling will
lead to serious accidents. Turn off the switch when finishing using!
Do not open the external part which will lead to get and electric shock since there is
high tension electricity inside!
Do not use water to clean the machine directly. The water will lead to electric con-
duction and electric shock accident!
Do not flap and put heavy onto it. It would damage the machine!
Do not touch the machine body and any other places of the machine while the
machine working or just finished working, in case scald with the high temperature.
ATTENTION
Turn off the switch eariler when is near to the mile field.
Which can avoid the broken of the product because of the lightning strike.
It is prohibit to use some hard sharp materials to break the control panel.
If the power cord is broken, it must be changed by a professional person from the
supplier or it's maintenance department to avoid danger.
KEEP RCES 580H HANDEL AWAY FROM TOP LAYER TO AVOID BURNING.
TURN OFF THE SWITCH AFTER USING.
Turn the thermostat on "0" position and turn off the power after finishing.
INSTALLATION REQUIREMENT
1. All the current supply device and link of the circuit must be installed according to
the safe regulation by the eligible appliance person.
2. It should be placed far from flammable materials.
3. Please check whether the link is ok or not towards the instruction before
installation.
4. It should be put in the steady place.
12
5. Please install, arrange from such temperature: from 0C to 35C, and the
ambient humidity is as follows: below 85%.
6. Please check if the attachment is complete or not before installation.
7. Please check if the outer appearance is broken or not before installation.
8. Please put it in a place which is easy to link and amend.
9. It is suggested that it should be put on a stead table or shelf. (Please put it in a
place which is airy and supplied with fire extinguisher).
10. The link of the electricity must be in light of the safe regulation.
11. Please check if the voltage and frequency are fit for the product specification
before linking.
12. Please install a double electrode and fuse plug between the produce and the
power cord. When it is working, the inaccuracy of the power is below 10%.
13. Please tight the cable slightly with a screw, which should be pin the power
cord slightly.
To pay attention: Please link the groundwire. The switch plug, patch(ing) board should
not be flexible. It will let the connector become hit and fry the power cord, which
arose a fire if link improperly.
WARNING
Do not use the power source out of the product's power description.
Do not use the air switch and anticreeping switch which is unsuitable towards the
safety standards.
ATTENTION
Installation and examination should be conducted by a qualified and professional per-
son.
OPERATION
ATTENTION: Please check all the specification and installation carefully before use,
make sure there is nothing wrong with it.
1. Link the power and start using this product.
2. Turn the thermostat clockwise. (Turn it for more, the temperature will become
higher) adjust the temperature in expected, hitting and the light shines, it means the
13