Replacing The Battery - Glentronics THE BASEMENT WATCHDOG Big Combo CONNECT Mode D'emploi Et Consignes De Sécurité

2
3
Remove
4
5
6
POSITIVE NEGATIVE
POST POST
7
4. Remove the fluid sensor from the battery.
Unscrew the wing nuts. Remove the battery
cables.
5. Clean the battery posts with a battery
terminal cleaner or a wire brush.
6. Clean any corrosion off of the ring connectors
on the ends of the battery wires. Us a stiff
brush or sandpaper. DO NOT apply corrosion
resisting sprays or pads to the terminal rings
or posts after you have cleaned them, since
this could prevent the system from charging
properly.
7. Replace the fluid sensor in the top of the
battery. Then replace the battery cables,
BLACK to the NEGATIVE (-) post and RED to
the POSITIVE (+) post. Tighten the wing nuts.
8. Plug the charger
and the blue AC
pump controller
back into the wall
outlet.
9. If any of the alarms
are sounding, press
8
the YELLOW button
on the front of the
control panel for one (1) second.

REPLACING THE BATTERY

DANGER
!
Risk of electrical shock or battery explosion,
which can cause serious injury or death.
Wear eye protection. Work in a well-
ventilated area. Do not smoke or allow a
spark or flame in the vicinity of the battery.
Avoid dropping metal tools on the battery.
If battery acid contacts eyes, flush with
water for 15 minutes and get prompt medical
attention. Review the safety instructions on
page 1.
REFER TO THE PHOTOS AT RIGHT
1. Unplug the charger and the blue AC pump
controller from the wall outlet.
2. Remove the cover of the battery box by
pushing in the tabs on the front and back,
then lifting up.
3. Fan the area around the top of the battery
with a piece of cardboard (or another non-
metallic material) to remove any hydrogen or
2
3
Remove
4
5
6
POSITIVE NEGATIVE
POST POST
7
8a 8b
oxygen gas that
may have been
emitted from the
battery.
4. Remove the fluid
sensor from the
top of the
battery. Unscrew
9
the wing nuts
and remove the
battery cables.
5. Remove the old battery from the battery box
and place the new battery in the box. Fill the
battery following the instructions on page 4
or 5.
6. Clean any corrosion off of the ring
connectors on the ends of the battery wires.
Use a stiff brush or sandpaper. DO NOT
apply corrosion resisting sprays or pads to
the terminal rings or posts after you have
cleaned them, since this could prevent the
battery from charging properly.
7. Replace the battery cables, BLACK to the
NEGATIVE (-) post and RED to the POSITIVE
(+) post. Tighten the wing nuts.
8. (a) If your battery has six (6) caps on the top,
rinse and dry the cap with the extra hole from
the old battery to remove any residue.
Replace the battery cap in the cell that is 2nd
from the POSITIVE post with the cap from the
old battery. Insert the fluid sensor in the cap.
(b) If your battery has two caps, each
covering three (3) battery cells, simply insert
the fluid sensor in the top of the battery next
to the arrow.
9. Plug the charger and the blue AC pump
controller back into the wall outlet.
10. If any of the alarms are sounding, press the
YELLOW button on the front of the control
panel for one (1) second.
Page 8