Operating Instructions; Charging Instructions; Wall Bracket Installation - Tennant Orbio Technologies 100−Tb Manuel De Fonctionnement

EN OPERATION
MACHINE SETUP
CONNECTING BATTERY
1. Loosen the two thumb screws on both sides
of the battery box.
2. Lift off the battery box cover.
3. Connect the loose cables to the battery's
positive (+) terminal.
(- )
4. Replace the battery box cover and tighten the
two thumb screws.
6

OPERATING INSTRUCTIONS

CHARGING INSTRUCTIONS

This unit can dispense approximately 1000
gallons (3785L) of Orbio Multi- Surface Cleaner
per battery charge. The battery level gauge will
indicate when the unit requires charging. Return
the unit to the charging station when the gauge
indicates "E".
Typical battery recharge time from 80% discharge
is 8- 10 hours. Charging can be done at anytime;
the battery level gauge does not have to be at "E"
to connect the charger. You may leave the battery
connected to the charger for extended periods of
time without damage to the battery.
Note: Battery must be charged for at least 10
hours before first use.

WALL BRACKET INSTALLATION

A wall bracket for the battery charger is included
with this machine. The battery bracket is intended
to protect the charger from damage and loss.
This bracket should be mounted in a dry location
near a 12V GFI protected circuit in an area
designated for charging. Use the enclosed screws
or other fasteners appropriate for your wall type.
This bracket should be mounted within 70" (178
(+)
cm) of the electrical outlet.
100- Tb/200- Tb DM20016 (1- 2013)