Charging The Battery - Würth 0827 940 45 Serie Traduction Du Mode D'emploi Original

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
GB
Operation
1
2
1. Light output – Spot light and main light
2. Handle - bendable
3. Magnet
4. Hook extandable
5. USB connection – power supply and USB-cable
for charging the lamp included in the delivery
6. Battery charge status (indicator light). When
switching the lamp on, the battery charge status
is displayed for approx. 5 seconds
7. On/Off switch – 1. step: Spot light
2. step: Main light
8. Boost Mode – High power light output
9. Hand strap
8
1
4
3
5
6
7
8
3
9
3

Charging the battery

• Before taking the hand lamp into service for the first
time charge it for 6-8 hours
• Fully charge the hand lamp before it is stored for a
longer period.
• Switch lamp off during charging.
• Remove the protective cap from the connector ( )
and connect the cable or charger.
• Connect the power supply to the mains socket
(100-240 V~).
• During charging, the indicator light (6)
flashes according to the charging status.
• If charging is completed, the indicator lights (6) light
up continuously.
• Do not charge the battery longer than required
to prevent overheating.
• Disconnect the charger and attach the protective cap
for connector (5).
Notes regarding operation
The switched-on lamp is very bright and the lamp
may get hot in the vicinity of the light outlet. When
the lamp is switched on:
• do not look directly into the light outlet.
• ensure that nobody is exposed to glare.
• do not cover the light outlet.
• do not put down the lamp with the light outlet
pointing downwards.

Publicité

Table des Matières
loading

Table des Matières