Operation Manual; For Your Own Safety; Safety Instructions; Charging The Battery - Würth ERGOPOWER TWINBLADE+ Manuel D'utilisation

OPERATION MANUAL

FOR YOUR OWN SAFETY

Please read this instruction manual before using
the lamp for the first time and comply with it.
Keep this instruction manual for future reference
or for subsequent possessors.
Warning - Do not look directly into the light
emitting lamp - Risk of eye injuries!
Always only use the charger recommended by the man-
ufacturer to charge the lamp. The use of a NON-recom-
mended charger can lead to a fire and destroy the lamp.
USAGE
The lamp is used properly if it is only used to illuminate
ordinary working areas and, in the process, complies
with the specifications indicated in the technical data.
Any other or additional use is not permitted.
The lamp may not be used:
• in areas with harmful gases, oils, acids, radiation, etc.
• in areas with an explosion risk.
This lamp complies with all relevant norms and
standards required for CE compliance. Compliance
with these standards is no longer guaranteed when
this lamp has been modified.

SAFETY INSTRUCTIONS

The lamp may get hot in the vicin-
ity of the light outlet. Therefore,
maintain a distance of at least 0.1m
• Do not open the lamp.
• There is a risk of short-circuit. Repairs on the lamp
may only be carried out by commissioned and
trained persons. Please contact your Würth branch.
Protect the battery against heat, e. g., against
continuous intense sunlight, fire, water, and
moisture. Danger of explosion.
• If the battery is damaged or not used correctly;
- vapours may leak and irritate the respiratory sys-
tem. Provide fresh air and contact a doctor in the
event of any discomfort.
- fluids can leak from the battery. Avoid contact with
these. Leaking battery fluids can lead to skin irri-
tation or burns. Rinse off with water if you should
come into contact. If the fluid gets into your eyes,
make sure you get medical help.
- there can be an internal short-circuit, the battery
may become overheated and explode or catch fire.
Any damaged lamp or charger may no
longer be used and may be exchanged by
the manufacturer only.
• Only stand the lamp on its head when it is
switched off
• The light source of this lamp cannot be exchanged.
The whole lamp must be exchanged when the
light source is defective.
OPERATION (SEE PAGE 2)
Light output – Spot light and main light
Battery charge status (indicator light). When
switching the lamp on, the battery charge status is
displayed for approx. 5 seconds.
a) On/Off switch:
1. step: Spot light
2. step: Main light one-sided with dimming function
b) On/Off switch:
Main light double-sided with dimming function
USB connection – power supply and USB-cable
for charging the lamp included in the delivery
Handle - bendable
Magnet
Hook - extandable

CHARGING THE BATTERY

• Before taking the hand lamp into service for the
first time charge it for 6-8 hours
• Fully charge the hand lamp before it is stored for
a longer period.
• Switch lamp off during charging.
• Remove the protective cap from the connector ( )
and connect the cable or charger.
• Connect the power supply to the mains socket
(100-240 V ~ ).
• During charging, the indicator light ( ) flashes
according to the charging status.
• If charging is completed, the indicator lights ( )
light up continuously.
• Do not charge the battery longer than required to
prevent overheating.
• Disconnect the charger and attach the protective
cap for connector ( ).
9