Audio-Technica ATW-2110 Installation Et Utilisation page 10

Channel
1
2
3
4
5
6
7
8
9
10
E
Note: All frequencies selected to avoid standard analog TV carrier interference.
N
For licencing information in the UK, please contact: JFMG Ltd, 33-34 Alfred Place, London, WC1E 7DP,
Tel: 0207 299 8660; Fax: 0207 299 8661; E-mail: info@jfmg.co.uk; Web: www.jfmg.co.uk
For other countries in the EU/Europe, please contact your local dealer or radio authority.
1. Use only fresh alkaline batteries. Do not use "general purpose" (carbon-zinc)
batteries.
2. Position the receiver so that it has the fewest possible obstructions between it
and the normal location of the transmitter. Line-of-sight is best.
3. The transmitter and the receiver should be as close together as
conveniently possible, but no closer than three feet (1 m).
4. The receiver antennas should be in the open and away from any metal. If
mounted in a rack, have the unit on top, or use an ATW-RA1 kit to front-
mount the antennas.
5. The transmitter and receiver must be set to the same channel number.
6. A receiver cannot receive signals from two transmitters at the same time.
For future reference, please record your system information here.
Receiver
UniPak™ Body-Pack Transmitter
Handheld Dynamic Microphone Transmitter
2000 Series Frequency Channel Plan
Frequency - MHz
848.500
854.900
855.275
858.200
858.650
860.400
863.025
863.325
864.300
864.950
Ten Tips to Obtain the Best Results
7. If the AF Level control of the receiver is set too high, it may over-drive the ``
input of the mixer or clip the output of the receiver, causing distortion.
Conversely, if the receiver output is set too low, the overall signal-to-noise
ratio of the system may be reduced. Please see Setting Levels section,
pages 7.
8. You need to change channels when a strong interference signal is
received (a strong RF signal is shown with the transmitter off).
9. In the UniPak transmitter, the microphone level trim or instrument level trim
input control not in use should be set to minimum.
10. Turn the transmitter off when not in use. Remove the battery if the
transmitter is not to be used for a period of time.
ATW-R2100
ATW-T210
ATW-T220
10
S/N
Serial Number appears on the label on the back of the receiver.
S/N
Serial Number appears on the label on the back of the transmitter.
S/N
Serial Number appears on the label on the interior of the transmitter.
TV Channel
Co-ordinated
Shared
Shared
Shared
Shared
Shared
Licence Exempt
Licence Exempt
Licence Exempt
Licence Exempt