Operation; Mode Of Operation - MeisterCraft MINITOOL MKB 160 E Traduction Du Manuel D'utilisation Original

5450620-Kleinbohrm-man 26.02.14 12:46 Seite 46
Inserting into tool
Press and hold down spindle lock (5),
Screw off the tensioning screw of the
tool holder (2). Insert a collet chuck (8)
which fits the tool into the tool holder,
position the tensioning screw and turn it
loosely into position. Insert the tool (c)
and tighten the tensioning screw with
the universal wrench (fig. 4).
CAUTION! Ensure that the grip
guard (4) is always in position
when working.
Attachment to flexible shaft
Pull the sleeve (d) of the tool
connection (12) of the flexible shaft
back and turn it until it locks into
position. Hold it in this position
(steps 1./2./3.). Screw off the tensioning
screw (2) and insert a collet chuck (8)
which fits the insert tool (c) into the tool
holder. Position the tensioning screw
and turn it loosely into position. Insert
the tool and tighten the tensioning
screw with the universal wrench (fig. 5).
8 – Operation
Start-up Operation
CAUTION! The appliance may be
operated only in a dry, well-lit
environment.
CAUTION! To prevent the tool
from starting accidentally,
ensure that the On/Off switch is in the
Off (position O) and the speed-control
knob (6) is set to the lowest setting
(setting 08) before connecting the
power plug to a socket. Before
switching on, ensure that the tool is
firmly and securely inserted into the
46
machine.
All manuals and user guides at all-guides.com
Speed-control (Fig. 6)
The machine has an electronic speed-
control feature. This makes it possible
to vary the speed continuously within
certain fixed limits depending on the
material being worked and the tool
inserted in the machine (appendix):
• Stage 08: minimum speed, approx.
8 000 1/min
• Stage 35: maximum speed, approx.
35 000 1/min
The set revolution speed (in thousands)
can be read off the display (a). Pressing
the "+" or "–" buttons increases and
decreases the revolution speed
respectively.
Starting
Switch the On/Off switch (1) to On
(position I) (fig. 6). The machine starts at
the low speed previously set.
Switching off
Set the revolution speed to level 08.
Set the on/off-switch to "off" (switch
setting O).
9 – Mode of operation
Exert only moderate pressure on the
workpiece to ensure that the speed
remains constant. Excessive pressure
does not accelerate the work but only
causes the machine to slow down or stall
thereby overloading the motor. Fix small
workpieces in position with a clamp.
Dust
Dust created during work may be
inflammable, explosive or harmful to