Installation And Setting; Operation - MeisterCraft MPF 400 Traduction Du Manuel D'utilisation Original

5455800-Powerfeile-man 04.03.14 09:35 Seite 33
• Observe the general safety notes with
regard to operating electrical tools.
7 – Installation and setting
Mounting the sanding head (Figure 2)
CAUTION! Unplug from the
power source!
Have the sanding head (9) ready in
such a way that the sanding stopper
surface (15) points downwards towards
the work piece. Fit the spiral spring (4)
into the groove (a) and (b).
Put the groove (c) at the rear end of the
sanding head onto the spring (d) at the
sanding head (16). Use the assembly/
adjustment screw (3) fit the sanding
head, through the screw holes (e) and (f)
fix to the sanding head holder.
Mounting the sanding belt (Figure 3)
CAUTION! Unplug from the
power source!
Push the tensioning lever (11) to
position A. Insert the sanding belt (13)
at the rear end of the sanding belt
holder (12) and use the front end to
position it over the roller guide (10) of
the sanding head.
Push the tensioning lever to position (B)
to tension the sanding belt.
Remove the sanding belt in reverse
order.
Adjusting the belt (Figure 4)
Connect to a power supply.
Switch the machine on (see Operation)
and set the band speed regulator (5) to
All manuals and user guides at all-guides.com
the lowest value 1. Observe the
movement of the belt.
If necessary, delicately adjust the
assembly/adjustment screw (3) forwards
or backwards until the sanding belt
operates smoothly and the roller
guide (10) is fully covered.
Dust collection mechanism (Figure 5)
• The electrical tool has a mechanism
• Clamp the dust collection bag
with the dust collection mechanism
attached.
8 – Operation (Figure 6)
The connection values of the power
supply must correspond to the
specifications on the type plate.
Connect the plug to a power supply.
Switching on
The machine has a 2 point security switch
to prevent it being turned on accidently.
Press and hold down the safety lock (1).
Only then is it possible to activate the
On/Off switch (2). The machine will
operate using the belt speed that has
been set.
CAUTION! Ensure that the
sanding belt is free of bends.
that enables you to collect or vacuum
the sanding dust.
opening as far as it will go onto the
exhaust opening (14) on the housing.
Emptying the bag frequently
increases the exhaust performance.
CAUTION! Wood dust is
dangerous! Thus, always work
33