Using The Timers; Setting The Clock; Setting The Daily Timer - JVC RC-BZ6BU Manuel D'instructions

7. Press the ¶ REC button on the Unit.
The PLAY button is pressed at the same time, the "REC" indi-
cator lights up, and the synchronous recording begins.
• The tape is recorded and then stops when it reaches the end.
• To continue recording to the other side of the tape, perform the
following steps.
1. Reverse the cassette tape and wind past the leader tape.
2. Press the CD 6 button and then press the ¶ REC button.
Then, the synchronous recording begins from the beginning of the
last track that was stopped at the end of the first side of the tape.
To stop recording, press the § STOP/EJECT button.
To remove the tape, stop the tape, and press the § STOP/
EJECT button again to open the cassette holder.
Notes:
• If the CD reaches its end before the tape, the tape will continue
to run until stopped. Press § STOP/EJECT button to stop
the tape.
During synchronous recording, the CD 6, 4, and ¢
•
buttons for the CD Player do not function.
If you press the ¶ REC button during playback the CD, record-
•
ing will start from the beginning of the track being played.

Using the Timers

SLEEP
REMOTE CONTROL RM-SRCBZ6
The timers let you control listening functions automatically.

Setting the Clock

You can set the clock when the Unit is turned on.
Notes:
• The clock must be correctly set for the timers to work.
• When setting the timers, you have two minutes in which to
complete the procedure. Otherwise, the setting is cleared and
must be repeated from the beginning.
(For 2 seconds) (Display "CLOCK") (Select the time)
1. Press the CLOCK/TIMER button on the Unit
and hold for more than two seconds.
2. Turn the JOG dial until the "CLOCK" indica-
tor blinks on the display.
The display changes as follows:
(For 2 seconds) ("CLOCK"indicator) (Select the time)
To Continue Recording to the Other
Side of the Tape———————————
When the tape reached its end and stopped, carry out the following
to continue recording to the other side of the tape.
1. Reverse the cassette tape and wind past the leader tape.
2. Press the ¶ REC button again.
The synchronous recording will begin from the last track
that was stopped at the end of the first side of the tape.
JOG dial
Timer indicator
CLOCK/TIMER
(Display when using the Timer)
3. Press the CLOCK/TIMER button.
The "CLOCK" indicator stays lit. The Unit's current set time
blinks on the display.
4. Turn the JOG dial to set the time.
Turn the JOG dial to the right or left to increase or decrease the
time. Turning it rapidly advances or decreases the time faster.
5. Press the CLOCK/TIMER button.
Then wait for 5 seconds or press the CLOCK/TIMER button
once again to return to the original display. The selected time is
set and the seconds start counting from 0.
CAUTION: If there is a power failure, the clock
loses its setting after approx. five minutes. The
display shows "AM12:00" and the "CLOCK" indi-
cator blinks, and the clock must be reset.

Setting the Daily Timer

Once you have set the Daily Timer. The timer will be activated at the
same time every day. You can cancel or re-activate the Daily Timer.
Note that the Timer indicator (
Daily Timer you have set is in effect.
Note: Perform each setting within 30 seconds. Otherwise, setting
is cleared and must be repeated from the beginning.
Analog clock
) on the display shows that the
9