Supplied Accessories; Installation - Vortice VORT KRYO-POLAR EVO 11 Notice D'emploi Et D'entretien

ENGLISH

Supplied accessories

Supplied accessories with the appliance (Fig. 1)
1

Installation

Installation of the exhaust hose
Use and installation of wall spacers (Fig. 2,2A)
- Fit the rounded connector (14) to the end of the
hose (13).
- Insert the end of the hose into the hole in the panel
(18)
- If the panel is too big. cut it to fit the window.
- Exhaust the hot air through the window or wall
(Fig.3).
- Fit the rounded connector (14) to the end of the ex-
traction hose.
- Make a hole (of more than 152 mm diameter ) in the
window or wall to accomodate the rounded connec-
tor.
When the appliance is disconnected from the window
or wall , use the blanking cap (15) to cover the hole.
The hot air extraction hose supplied with the ap-
pliance can be extended by 300 to 1500 mm (Fig
4,5); It is best to use the smallest possible extension
(Fig. 6).
13 - Exhaust hose;
14 - Adaptor - for insertion over hose and into window
spacer (or into a hole in the wall/window)
15 - Cover for adaptor n°14
16 - Window spacer - for filling the open window
space.
17 - Window spacer - for filling the open window
space.
18 - Window spacer - for filling the open window
space and with hole for connection to exhaust hose.
19 - Drain tube for continuous drainage
20 - Active carbon filter
21 - Remote control
2
2A
23