Vornadobaby whole room heater Mode D'emploi page 9

Stop Crib Sensor Remote Sync
1. To turn the CSR Off, slide the switch to the Off
position. The green light will begin to blink.
After approximately 4 minutes the green light
will turn Off.
Off
16 English
2. If CSR is Off or not within range of Sensa the
green light will not be illuminated and the ( )
icon will appear on the LCD Screen.
Note: To replace batteries, open battery door
on the back side of the CSR (you will need
to loosen the small screw on door using a #1
Phillips screwdriver). If necessary, clean the
battery contacts and also those of the device
prior to battery installation.
Replace
Batteries
Crib Sensor Remote Placement
x
1. Attach the CSR to the crib or place the CSR near the crib, but out of reach from child . The CSR will
now monitor the selected Heat setting.
DO NOT PLACE CSR IN CRIB
NO
OK
English 17