How To Use - Vornadobaby whole room heater Mode D'emploi

How To Use

Operation
1. Press Power button On ( ). The red light and
Control Panel will illuminate when On. The
Control Panel will dim after approximately 15
seconds.
2. Select Heat setting ( ). Low Heat 600 watts or
High Heat 1200 watts. The Control Panel display
will turn pink on Low Heat and orange on High
Heat.
12 English
3. For fan use only without heat, select Fan Only
on the Heat setting. The Control Panel display
will turn blue.
4. Set desired Temperature by the pressing the
(+/-) button.
5. The Actual temperature will display the room
temperature. The Set temperature will display
the desired temperature setting.
6. Press the Timer ( ) to turn the unit off
automatically. Adjust in 2 hour intervals, up to
12 hours, by pressing either ( ) or (+/-). To
cancel Timer operation, select 0 hours or hold
( ) for three seconds.
Note: Previous control settings are kept for the
next time the unit is powered On, unless unit is
unplugged or tipped over.
To change between Fahrenheit and Celsius,
press (+) and ( ) at the same time and hold for
four seconds.
English 13