Vornadobaby whole room heater Mode D'emploi page 11

Troubleshoot
Unit fails to Unit is not plugged in. Plug Power Cord into electrical outlet.
power on.
Household circuit breaker / ground fault interrupter has tripped or
blown a fuse. Reset circuit breaker / ground fault interrupter, or replace
fuse (See IMPORTANT SAFETY INSTRUCTIONS).
The unit has overheated. Automatic Safety Shut-Off has initiated (See
RESETTING YOUR VORNADO HEATER).
Unit is damaged or in need of repair. Cease usage and unplug.
Contact Consumer Service for assistance.
Unit fails to Check to see if the unit is locked. If lock icon is lit, hold down on icon
(for 3 seconds) until the light turns off. If the unit is unlocked and still
power off.
does not power off, unplug unit and contact consumer service.
Ensure unit is set to High Heat and thermostat is set to highest
Unit is not
temperature setting.
producing
sufficient
Close all doors and windows to contain heat.
amount of heat.
20 English
Unit is not Allow the unit to fully circulate the heat throughout the room, may take
producing
several minutes.
sufficient
amount of heat.
(cont.)
Unit power on
Power off and unplug the unit. On the bottom of the unit, there is a
gray tip over switch. Push in 4-5 times ensuring it is not stuck. Set unit
but there is no
down on flat surface. Be sure power cord is not under unit. Plug unit in
heat.
and power on. Turn to highest heat setting.
Make sure the CSR is within 15 feet of unit.
CSR remote will
not sync.
Reset the CSR remote to re-establish connection (See CRIB SENSOR
REMOTE).
Replace batteries. Note: Even when Sensa is powered off, to maximize
battery life, it is recommended you turn the CSR remote off (slide
switch to the off position).
English 21