Sensa features a child-resistant button,
keeping the heater in parents' desired setting.
Locking Controls
1. To engage this feature press and hold the
Control Lock button ( ) for 3 seconds. The
Control Lock icon will blink 3 times rapidly to
show it is locked.
Note: The Control Lock icon will blink 3 times if
any button is pressed while the Control Lock is
engaged. While this feature is engaged you will
not be able to change the settings or Power the
unit On or Off. If the unit is powered Off, you may
still engage the Control Lock.
14 English
2. To turn this feature Off press and hold the
Control Lock button ( ) for 3 seconds.
Note: If Sensa is tipped over, all power will
automatically shut-off. The Control Lock feature
will be disengaged.
Crib Sensor Remote
To keep your baby comfortable, use the wireless Crib Sensor Remote (CSR). The CSR will sense
the temperature at its location, up to 15 feet away from Sensa. On the control panel, the Actual
temperature will display the approximate temperature of the room at the location of the CSR.
Note: Due to product testing, your CSR may already be synced. If so, a solid green light will appear
on your Sensa once the CSR is powered On. If not, sync the CSR using the steps below.
Sync Crib Sensor Remote
You should only need to set up the connection
one time upon first use of your Sensa. If for some
reason the CSR loses its connection – repeat
these instructions.
Note: Sensa must be powered On to sync
the CSR.
1. Place 2 AA batteries (included) into CSR.
Ensure the screw is securely installed.
2. Slide the switch to the On position. Flip over
the CSR and press the link button for 3-5
seconds. A green light on the front of Sensa
will begin to blink. While the green light is
blinking, release the link button. Press the
link button again to fully sync. Green light will
remain solid.
3. The CSR is linked when the green light
remains On and the LCD Screen displays the
word "remote". For accuracy Sensa will send a
signal to the CSR every 3 minutes.
On
Link Button
English
15