Zenoah BCZ260L Manuel D'utilisation page 12

To assemble the loop handle
1. Attach the loop handle onto the shaft between the
arrows.
2. Move the spacer into the slot of the loop handle.
3. Attach the nut, the knob and the screw, do not make
it to tight.
4. Adjust the product to a comfortable position.
5. Tighten the bolt.
To assemble the J-handle (BCZ260L,
BCZ300L, BCZ400L)
WARNING: Only grass blades/grass cutters
or trimmer heads/plastic blades may be
used when the J-handle is attached. Do not
use saw blades or clearing blades with the
J-handle.
1. Attach the J-handle to the loop handle with 3 screws.
2. Adjust the product to a comfortable position.
12
3. Tighten the screws.
To install the suspension ring
(BCZ260L, BCZ300L, BCZ400L)
1. Install the suspension ring between the rear handle
and the loop handle.
2. Adjust the ring to make the product balanced, and
easy to use.
3. Use the harness and attach it to the suspension ring
when you use grass blades.
Assembly of blades and trimmer heads
WARNING: When you install the cutting
attachment it is very important that the
raised section on the drive disc/support
flange engages correctly in the centre hole
of the cutting attachment. If the cutting
attachment is install incorrectly it can result
in serious and/or fatal personal injury.
353 - 003 - 06.01.2018