If A Problem Occurs - Atlantic MARADJA Notice D'utilisation Et D'installation

GB
Problem encountered
The radiator does not
heat
The radiator heats all
the time
The radiator does not
heat enough
Traces of dirt collect
on the wall around the
radiator
The heating pictogram
is displayed on the
screen when the
radiator is in ECO
mode
For radiators equipped with a programming system or controlled through the pilot
wire.
The radiator does
not follow external
programming controls
User's manual

7 - IF A PROBLEM OCCURS

If you are in programming, make sure that the program is in
COMFORT mode.
Make sure that the circuit breakers of the installation are
closed or that the load shedder (if you have one) has not
switched the heating off (see part X).
Check the air temperature in the room; if it is higher than
the set temperature, the heating pictogram will not come on
and the radiator will not heat.
Check that the radiator is not located in a draft, and that the
temperature setting has not been modified.
Increase the Comfort set temperature.
If the setting is at the maximum, make the following checks:
-Check if there is another heating source in the room
- Make sure that your radiator is only heating the room (door
closed).
- Have the radiator power supply voltage checked.
- Check if the power of your radiator is appropriate for the
size of your room (we recommend about 100W/m
ceiling height of 2.50 m).
Dirt is caused by poor quality of ambient air. In this case, it
is recommended that good aeration of the room (ventilation,
air inlet, etc.), and cleanliness of the air should be checked,
and do not smoke indoors. This dirt does not justify
replacement of the radiator under guarantee.
This operation is normal. The radiator can warm up so as to
maintain an Eco temperature.
Make sure that the programming control unit is used
correctly (see user's instructions), that the programming unit
is properly engaged in its housing and that it is functioning
normally (check the condition of the batteries, fuse, etc. ).
Make sure that your radiator is in Program mode and that
the external « centralised » program is assigned to the
required day of the week.
Check to be made
for a
2

71