Publicité
Les langues disponibles
Les langues disponibles
Ford Mondeo Clipper
1993 - 2000
Ref.
Fitting instructions
1)
Loosen the exhaust in the rear and disassemble the heat shield.
2)
The mounting points (A) match the provided holes in the sides of the chassis beams. Place the washers
and small tubes on the bolts and attach them in the provided holes via the side of the chassis.
3)
Place the tow bar in between the chassis beams, matching the provided holes as mentioned in point 2.
Affix the bolts in their permanent position and tighten them. Assemble the (*) and tighten everything
firmly.
4)
Re-assemble the exhaust and the heat shield in their original positions.
Composition
1 tow bar reference 0419
1 ball T43L003
4 bolts M12-40
6 bolts with nuts M10-130
6 tubes 16/95
6 washers 40-12-4
6 safety washers 10 mm
4 safety washers 12 mm
1 security shackle (800053)
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
0419
(*)
(*)
(A)
(A)
(A)
(A)
(*)
(*)
All bolts and nuts: quality 8.8
Publicité
