V2 ZENIA Mode D'emploi page 64

INSTALLATION OF SENSIVA
PHOTOCELL OR BLINKO FLASHING
LIGHT
On the cabinet sides there are holes for installing SENSIVA and
BLINKO.
To install these accessories onto the cabinet of the barrier, please
follow the following steps:
1. Remove the cabinet's two lateral stoppers of the cabinet
2. Screw the base of the photocell / flashing light using the
4 preset holes Q positioned under the stoppers
(use self-tapping screws (Ø 3,9 mm ISO 7049)
3. Pass cables for the connections thought the R hole
4. Carry out the electrical connections following the indications
found on page 43 (paragraph PHOTOCELLS)
ATTENTION: carefully follow the indications found
in the instruction manual attached to the photocells
5. Close the container
62