V2 ZENIA Mode D'emploi page 63

DISPLAY DATA
Strt
StAn
no
SLA
APCH
PrES
oroL
StoP
no
invE
ProS
Foto
no
APCh
CFCh
Ch
Ft.tE no / Si
CoS
no
Ch
Co.tE
no
Foto
rESi
FinE
no
Si
CITY10+ FUNCTION TABLE
DESCRIPTION
Start entries
- Standard Mode
- Entries from disabled terminal strip
- SLAVE Mode
- Open/Close
- Man present Mode
- Clock Mode
STOP input
- input is disabled: the STOP command is not activated
- The STOP command stops the barrier: the successive START reverts the motion
direction
- The STOP command stops the barrier: the successive START does not revert the
motion direction
Photocell input
- disabled input
- Always enabled input
- Enabled input in closing and with closed barrier
- Enabled input only in closing
Photocell test
Obstacle detection input
- Disabled input
- Input enabled during closing
Functional test of the obstacle detection sensors
- Test disabled
- Test enabled by optical sensors.
- Test enabled for resistant rubber sensors
End programming
- Does not leave the programming menu
- Leaves the programming menu storing the set parameters
61
DEFAULT MEMO
StAn
no
no
no
no
no
no