Breville the Sous Chef 12 Manuel D'instructions page 21

PROBLEM
The motor does
not start
The food processor
shuts off during
operation
The motor
slowed down
during operation
The food processor
vibrates/moves
during processing
EASY SOLUTION
•
There is a safety interlock switch to prevent the motor from starting if it is not
properly assembled. Make sure the processing bowl and lid are securely locked
into position.
•
If you are slicing or shredding and the above solution does not work, make sure
that the food contents in the feed chute are cut below the maximum fill line so
that the activation rod can engage the motor.
•
Make sure the large food pusher is inserted in the feed chute low enough to
engage safety interlock switch.
•
If the motor still will not start, check the power cord and power outlet.
•
The lid may have become unlocked; check to make sure it is securely in position.
•
If the motor overloads, all buttons will flash in unison.
Unplug at the wall, and allow the food processor to cool for 20–30 minutes
before resuming.
•
This is normal as some heavier loads (e.g. slicing/shredding cheese) may
require the motor to work harder. Reposition the food in the feed chute and
continue processing.
•
The maximum load capacity may have been exceeded. Remove some of the
ingredients and continue processing.
•
Make sure the rubber feet at the bottom of the unit are clean and dry. Also make
sure that the maximum load capacity is not being exceeded.
•
This is normal as some heavier loads may require the motor to work harder.
21