Set Language; Service Display; Switching Off The Machine - Weidmüller Crimpfix R Notice D'instructions Originale

6.7 Set language

► Select Menu 10.
► To activate the menu, press E.
10. Language
---------------------------
C E
 
► Press  until the desired language is displayed.
The selected language is adopted immediately.
► To reach the production menu again, press C, or choose
another menu with the arrow keys.

6.8 Service display

1. Production menu
Ready Device is ready for operation
––– Service ––– Service display appears after
every 400,000 work cycles.
Step: 2/0
C E
 
When the machine is switched on, the service display
flashes three times. After that the machine is ready for op-
eration.
To maintain the machine's performance capa-
bility for as long as possible, you should keep to
the service intervals specified.
– Small service after 400,000 work cycles
– Big service after 800,000 work cycles
Refer to the Weidmüller representative respon-
sible for your country.

6.9 Switching off the machine

► Switch the machine off.
The valves are audibly relieved. The display goes out.
Only RS: When you finish the work, you should
empty the waste container and put it back into
the machine (see section 7.4).
2549630000/00/09.2017
Operating the machine
37