Yamaha CDR-D651 Mode D'emploi page 23

RECORDING FUNCTIONS .....................................................
CD TEXT editing
This unit can edit CD TEXT data on the disc to be used for
recording. Each name can contain up to 23 characters
using capital and lower case letters of the alphabet,
numbers, and symbols. CD TEXT data editing should be
complete before finalization is performed. Once the disc is
finalized, CD TEXT data editing is not possible.
Making a name using the MULTI JOG knob
1.
Load a disc that you wish to enter a name for on
disc tray B.
To make a disc name, press and rotate the MULTI
JOG knob to select "Disc Name" in the set menu while
this unit is in the stop mode. To make a track name,
select "Track Name" in the set menu by rotating the
MULTI JOG knob. Then select the track that you wish
to enter a name for using y while this unit is in the
stop mode. Follow the steps described below to
complete a disc and track name.
2.
When the MULTI JOG knob is pressed, a cursor
appears in the display. Rotate the MULTI JOG
knob to select the character you wish to use from
the character selection. Press the knob when you
find the desired character.
Press the knob again to enter the character. Character
selection appears in the display in the order of
alphabet capital letters, alphabet lower case letters,
numbers, and symbols. Rotate the MULTI JOG knob
clockwise or counterclockwise to find the desired
character.
3.
After the character is selected, press the knob to
enter the character entry and move the cursor to
the next space.
Repeat this step to complete the name. Each name
can contain up to 23 characters.
4.
After all characters are entered, press and hold
the MULTI JOG knob for 2 seconds to enter the
name.
20
E-
Making a name using the remote control
1. 1
Repeat step in "Making a name using the
MULTI JOG knob" to select "Disc name" or "Track
name" and press EDIT while this unit is in the
stop mode. Then the cursor appears in the
display.
2.
Select the characters to be used using the
numeric buttons.
Alphabet capital letters, alphabet lower case letters,
and numbers switch each time the buttons are
pressed. To make a space, press SPACE. To use a
symbol, press SYMBOL to select the desired symbol.
3.
Select the next character with the appropriate
button.
When using the same button, move the cursor to the
next space by pressing y. Repeat the steps
described above to complete a name. Each name can
contain up to 23 characters.
4.
After all characters are entered, press SET to
enter the name.
To correct names
Press t or y for the disc tray B (t or y on the
remote) to move the cursor to the character to be corrected.
Press ERASE (DELETE on the remote) or select the correct
character and press SET to enter the new name.
Editing on the disc
After the disc name and all track names are complete, the
TOC indicator blinks in the display. Perform finalization in
order to record this CD TEXT data on the disc. (See the next
page for the finalization procedure.) You will then have a
complete disc with CD TEXT data.
Notes
• CD TEXT data is normally edited while this unit is in the stop
mode. However it is possible to edit the disc name and track
name for the track being played or recorded. In this case,
perform finalization after pressing a when editing is complete.
• When editing is complete, if you attempt to open the disc tray
before finalization is performed, "TEXT Save?" appears in the
display. In this case, press w/d (w on the remote) twice to start
finalization. If the disc tray is opened by pressing v (OPEN/
CLOSE on the remote), the edited CD TEXT data will be lost.