Husqvarna 967322401 Mode D'emploi page 8

INSTALLING COLLECTOR
1. Using two 15/16" wrenches, remove the lower ROPS bolts
(A) on each side, retaining washer and nut for next step.
2. Install a hitch pin (B), washer and nut on each side where
the ROPS bolt was removed. Tighten hitch pins and nuts
with 15/16" and 1-1/4" wrenches.
3. Install the mount pins (C) through ROPS tube in predrilled
holes approximately 18" up from bottom of ROPS tube.
The pin will pass from the outside in, so the threads are
on the inside of the tube. Secure each side with nuts and
tighten using 3/4" and 9/16" wrenches.
4. Attach the hitch tubes (D) to the hitch assembly (E) with
2-1/4" bolts and nuts as shown. Tighten using 9/16" and
3/4" wrenches. Install pin mounts (F) through the hitch
tubes and hitch assembly and secure with nuts.
E
D
5. Attach the straps (G) to the previously installed mount pins
at the hood assembly.
NOTE: the short leg of the straps attach at the cross plate end
and the straps angle inward.
ASSEMBLY
A
C
B
F
6. Secure the straps with washers and retainers in the mount
pins.
G
7. With the hood/hitch assembly behind the mower, place the
lower slotted portion of the hitch tubes over the hitch pins
attached to the bottom of the ROPS.
NOTE: be sure that the retention pin (H)hooks over the front of
the hitch pins.
8. Lift up on the rear of the hood and attach the free ends of
the straps on the upper pins installed in the ROPS. Secure
with washers and retainers.
9. Release the hood latches (I) of the hood and lift hood
open. If hood does not stay open, tighten hood hinge bolts
slightly.
10. Install collector bags (J), close and latch hood.
11. Attach the hose between the hood assembly and the
blower assembly.
8
H
I
J