Mains Connection; Operation - Deltafox DC-HPW 2115 Traduction De La Notice D'utilisation Originale

GB
6. Plug in and turn the jet tube with high-
pressure nozzle (17) or the jet tube
with flat spray nozzle (18) to connect
to the jet gun (1).
7. To change the jet tube (17/18) push in
the tube or brush and turn in the oppo-
site direction.
8. The jet tube with high-pressure nozzle
(17) produces a rotating water jet and
is designed for low water consumption
work.
9. The jet tube with flat spray nozzle (18)
produces a flat wide jet particularly
suited for large surfaces.
Turn the tip of the nozzle left to reduce the
width of the jet. Turn the tip of the nozzle
right to expand the width of the jet.

Mains connection

The pressure washer you have acquired
is already fitted with a mains plug. The
equipment is designed for connection to
an earthed wall socket with a RCD (Re-
sidual Current Device) at 230 V ~ 50 Hz.
Only operate the pressure washer
after all the above points have
been observed.
1. Ensure that the pressure washer is
turned off by its ON / OFF switch (10).
2. Insert the mains plug into the mains
socket

Operation

Be prepared for the recoil force
of the emitted water jet! Ensure
that you are standing firmly and
that you are holding the gun (1)
securely, otherwise you could
injure yourself or other people.
22
Never operate the pressure wash-
er with a closed water tap. Dry run-
ning will damage the washer!
1. Turn on the water tap entirely.
2. Switch on the pressure cleaner with
the ON / OFF switch (10).
Only ever switch on the pressure
cleaner once you have connected all
of the water pipes and they do not
leak.
The motor switches on until the re-
quired pressure has built up. After
the pressure has built up, the motor
switches off.
3. Press the gun starting lever (1). The
nozzle operates by pressure and the
motor switches back on.
Releasing the starting lever causes
the equipment to switch off. The sys-
tem remains pressurised.
In the event of leaks in the water
system, switch off the equip-
ment immediately at the on/off
switch (10) and disconnect the
equipment from the mains at the
mains power cord (5). Risk of
electric shock! Start afresh with
making the water connections
(cf. "Start-up / Operation").
If there is still air in the device, please
proceed as follows:
To vent the supply hose:
1. Remove the quick connector for gar-
den hose adaptor (14) on the water
connection (9) and open the water tap
until water comes out with no bubbles.
2. Switch off the water tap.
3. Connect the supply hose to the water
connection (9) on the equipment using