Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MICROWAVE HOOD COMBINATION SAFETY
Tools and Parts
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Measuring tape
■
Pencil
■
Masking tape or thumbtacks
■
Scissors
■
No. 2 Phillips screwdriver
■
No. 3 Phillips screwdriver
■
for 1/4 - 20 x 3" (7.6 cm)
bolts
Drill
■
3/16" (5 mm), 3/8" (10 mm),
■
5/8" (16 mm) drill bits
3/4" (19 mm) hole saw
■
Diagonal wire cutting pliers
■
Stud finder
■
7⁄16" (11.11 mm) socket wrench (or box wrench) for 1/4" x 2"
■
(6.4 mm x 5.1 cm) lag screws
1
/
" (3.8 cm) diam. hole drill bit for wood or metal cabinet
1
■
2
Keyhole saw
■
Caulking gun and weatherproof caulking compound
■
Duct tape
■
2
INSTALLATION REQUIREMENTS
Parts Supplied
For information on reordering, see the "Replacement Parts"
section.
NOTE: The hardware items listed here are for wood studs.
For other types of wall structures, be sure to use appropriate
fasteners.
A
B
C
A. 3/16 - 24 x 3" round-head
bolts (2)
B. 1/4 - 20 x 3" flat-head bolts (2)
C. Washers (2)
D. 3/16" toggle nuts (2)
E. 1/4" x 2" lag screws (2)
F. Sheet metal screws 1/8" x 3/8"
(3.2 mm x 9.5 mm) (2)
G. Power supply cord bushing (1)
H. Damper assembly (for wall or
roof venting)
NOTE: Depending on model, aluminum grease filter and
charcoal filter may be combined.
Materials Needed
Standard fittings for wall or roof venting. See the "Venting
■
Design Specifications" section.
D
E
F
H
Not Shown:
Upper cabinet template
■
Mounting plate (attached to
■
back of microwave oven)
Cardboard template (part of
■
packaging) or wall template
Aluminum grease filters
■
Charcoal filters (Depending
■
on model, charcoal filters may
not be included. See User
Instructions.)
G
Publicité
Table des Matières
