Machine Information; Technical Specifications - VONROC AMIATA PH511AC Traduction De La Notice Originale

• If the supply cord of this power tool is dam-
aged, it must be replaced by a specially pre-
pared supply cord available through the service
organization.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm². If you use an extension
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
This product is designed as a patio heater for
domestic environments. The heater is intended for
private gardens or other outdoor areas at home.
The heater may not be used to heat an indoor
space, usage as a non-household outdoor space
heater or for the drying of textiles or other mate-
rials. This heater is not equipped with a device to
control the room temperature so do not use this
heater in spaces when they are occupied by per-
sons not capable of leaving the room on their own,
unless constant supervision is provided. The device
is to be used only for its prescribed purpose. Any
other use is deemed to be a case of misuse.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power
Power settings
Heating element type
Heating time
Wave length
Radiant efficiency
Heating distance
Heating area
Electronic soft start
Ingress protection class
Protection class
Weight
WWW.VONROC.COM
PH511AC
220–240 V ~
50-60 Hz
2200W
1: 730W
2: 1460W
3: 2200W
Quartz
20 seconds
1.4-3.0
60%
3-4m
15m²
Yes
IP34
Class I
1.50 kg
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-4.
1. Heater
2. Protective grill
3. Power level indicator
4. Power cable
5. Pull cord (on/off switch)
6. Upper tube
7. Small cable holder
8. Middle tube
9. Large cable holder
10. Lower tube
11. Cover
12. Baseplate
13. Long bolt
14. Short bolt
15. Clamping ring
16. Extendable tube
17. Screws
3. ASSEMBLY
This heater should be installed by a
competent person, i.e. a qualified electrician.
Always disconnected the heater from the
electrical supply and allow it to cool before
installation.
Assembling the heater (Fig. B­F)
Always mount the device with the supplied
accessories.
Before starting to assemble the device, take the
following into consideration:
• Place the device on a firm, level surface. The
device may never be placed at an angle!
• The device must be placed so that there is 100
cm of free space between the heater and object
or wall, measured from the front or side. There
must be at least 1.80 m between the ground
and the underside of the device. There must be
at least 30cm clearance between the device
and the ceiling.
• Do not install the heater on or near an inflam-
mable surface.
• If the heater is to be used outside, a weather-
proof outlet is highly recommended.
• Before drilling ensure that there are no wires or
EN
7