Safety Instructions; Electrical Safety; General Safety Warnings; Work Area - Hilti SF 151-A Mode D'emploi

Power tool
Torque with tool set to drilling
symbol (soft/flexible joint)
Torque (driving screw in hard
material) set to drilling symbol
en
Torque range (15 settings)
Hammering speed
Hammer drilling in brick and
masonry (max. length 80 mm)
Battery
Rated voltage
Capacity
Energy content
Weight
Temperature monitoring
Type of cell
No. of cells

5. Safety instructions

NOTE
The safety rules in section 5.1 contain all general
safety rules for power tools. The instructions at
5.1.2a, 5.1.2d, 5.1.2e, 5.1.3c and 5.1.4c are not
relevant to this power tool.

5.1 General safety warnings

WARNING! Read all instructions! Failure to follow all
instructions listed below may result in electric shock,
fire and/or serious injury. The term "power tool" in
all of the warnings listed below refers to your mains-
operated (corded) power tool or battery-operated
(cordless) power tool. SAVE THESE INSTRUCTIONS.

5.1.1 Work area

a) Keep work area clean and well lit. Cluttered or
dark areas invite accidents.
b) Do not operate power tools in explosive atmo-
spheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c) Keep children and bystanders away while oper-
ating a power tool. Distractions can cause you to
lose control.
4
Printed: 07.07.2013 | Doc-Nr: PUB / 5070660 / 000 / 00
SF 151-A
Max. 33 Nm
Max. 70 Nm
2...12 Nm
SFB 150
15.6 V
2 Ah
31.2 Wh
0.94 kg
Yes
Nickel-cadmium SUB C size
13

5.1.2 Electrical safety

a) Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
b) Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
c) Do not expose power tools to rain or wet con-
ditions. Water entering a power tool will increase
the risk of electric shock.
d) Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges
or moving parts. Damaged or entangled cords
increase the risk of electric shock.
e) When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a
cord suitable for outdoor use reduces the risk of
electric shock.
SFH 151-A
Max. 33 Nm
Max. 70 Nm
2...12 Nm
36,000/min
1.5...6 mm
SFB 155
15.6 V
3 Ah
46.8 Wh
0.96 kg
Yes
Nickel-metal hydride SUB C size
13