Emerson QC01 Serie Guide D'installation page 9

7 Maintenance
The FieldQ Control Modules are designed to
operate without maintenance. For any further
maintenance to the actuator see Installation &
Operation Manual FieldQ Valve Actuator,
DOC.IOM.Q.E or contact your local FieldQ
representative.
Installation, adjustment, putting into service, use,
assembly, disassembly, maintenance and repair of
the Control Module must be done by qualified
personnel.
8 Optional Controls
8.1 Manual Control options
(see figure 11)
For commissioning, emergency or maintenance
purposes, the FieldQ can be supplied with Manual
Control options. These options can operate the
actuator when there is air pressure available, but
no control signal or power supply.
1 "Push" version. Pressing the spring return
button will operate the actuator. Releasing the
button will bring back the actuator to its original
position.
2 "Push & Lock" version. To operate this
version, use a screw driver. Push and turn it
90°, to lock it in position and keep the actuator
in its operated state.
It is possible to rotate the screw multiple cycles.
The unit will toggle every 90° between "locked"
(1) and "unlocked" (0).
"Push" "Push & "Lock
1
Fig. 11 Manual Control options
DOC.IG.QC01.1 Rev.: B
1
0
1
1
2 (90˚)
1 = "locked"
0 = "unlocked"
8.2 Speed control option
(see figure 12).
The FieldQ can be supplied with Speed Control
options. There are two versions of this option:
- One Way.
- Two Way
For more detailed information on these two speed
control version see data sheet 1.605.01 or manual
DOC.IOM.Q.E
To adjust the Speed Control options:
1 Remove the nut cap (1).
2 Clockwise rotation of the adjustment screw
reduces the speed.
3 Counter clockwise rotation of the adjustment
screw increases the speed.
4 Replace the nut cap.
9 Related Information
Other documents containing information related to
the FieldQ Module include:
- 1.604.01
data sheets
- DOC.IOM.Q.E
Maintenance Manual.
These documents are available, in multiple
languages, for download from www.FieldQ.com
0
Fig. 12 Speed control operation
9
FieldQ Smart Control Module
Installation Operation &
1
December '06
En