Brandson Equipment 303112 Mode D'emploi page 22

5 Installation
Take the fan out of the package and check whether the device as well as installation
material is complete (see table). Please contact the supplier if any part is missing
or has been damaged.
Connect the metal base (13) with the coupling piece (5). Screw this tight in connec-
tion to the mounting screws (6).
Remove the nuts and screws from the top side of the centre bar (4) and mount the
motor unit on the centre bar.
10
3
4
22
9 2
Remove the screws from
the top side of the centre
bar and the screws from the
motor unit.
Place the motor unit on the
centre bar (4) and secure it
using the carriage bolt (10).
Mount the small knurled
screw (9) and the limiting
screw (2) as shown in the
figure.
English