Chromatherapy Option; Maintenance; Filtration - BWT Spas ST 2.18 Notice D'installation Et Conseils D'utilisation

4.2

Chromatherapy option

The Chromatherapy option consists of LED lighting located just under the water line around the periphery
of the spa, inundating the water with a homogeneous, soothing, multi-directional light that contributes to
your well-being.
The control panel (LIGHT key) allows selection of the lighting mode from the available options, fixed
colour, cross fades between the various colour with transitions of carious lengths (see the instruction
manual provided with the control pad for more information).
5.

MAINTENANCE

5.1

Filtration

Spa water is filtered through one or two filter cartridges (depending on the spa model) located in the
skimmer body. These cartridges need to be cleaned regularly and replaced if necessary.
We recommend that you use two filter cartridges (or two sets of filter cartridges) alternately so that each
cartridge (or set of cartridges) may be cleaned properly while the other is in use.
Periodic maintenance may be programmed using the spa pack's electronic timer. The timer will then
remind the user to clean the cartridges at a pre-determined time (see maintenance timer configuration in
the spa pack instruction manual).
The cleaning interval will vary from one spa to another depending on several criteria (indoor, outdoor
installation, number of users, frequency of use, water temperature, etc.). At the outset, filter cartridges
should be checked every week if the spa is installed outdoors or every 2 weeks if the spa is installed
BIEN-ÊTRE
Designation
Diverting valve
Air controller
Stationary massage jets, the direction may
Directional jets
be adjusted. The flow rate of each jet is set
(70 mm and 95 mm)
Rotating jets
(70 mm, 95 mm)
Dual rotating jet
(95mm)
Mini jet
Description
Directs the flow to one zone or another
Controls the flow rate of air bubbles
released into the massage jets.
individually by rotating the outer ring.
Rotating massage jet. The flow rate of
each jet is set individually by rotating the
outer ring.
Rotating massage jet. The flow rate of
each jet is set individually by rotating the
outer ring.
Air jet supplied by the blower (option).
2021/02 - Indice de révision : E - Code : 37791
55/64