Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.
INSTALLATION AND COMMISIONING
3.1
Tools required
4 people will be needed to carry the spa.
Tools required:
•
Phillips head screw drivers:
−
PH1 cover fasteners, drain line adapter, removing the control panel casing, and connecting the live and
neutral wires of the power cable.
−
PZ2 Step fastening screws.
•
Flat head screw driver for the earth wire of the power cable.
3.2
Siting
Outdoor installation:
•
Do not install the spa near deciduous bushes or deciduous trees.
•
Check that rain water will not accumulate under or around the spa.
Prolonged immersion of the surface underneath the spa can lead to damage
Indoor installation:
•
We recommend that you ensure that the spa may be easily removed from the installation site if required
(do not wall the spa in).
•
Make sure that the humidity that the spa will generate in the room will not damage decorative
elements or any structures in the room (wooden floors, wood, materials, paintings, etc.).
•
Install a dehumidification system or ventilation system in the room, particularly if the spa room is small.
3.2.1 Portable spas
The ground under the spa should be stable and perfectly flat surface (check using a spirit level). If necessary,
use wedges to level the spa having first checked that the wedges are strong enough to support the weight
of the filled spa.
Verify that the ground, balcony or terrace will bear the total weight of the spa (plus water, plus occupants)
without any risk of collapse.
Leave a gap of at least 80 cm around the entire periphery of the spa to facilitate access to the components
behind the surround for maintenance.
To empty the spa, it must be possible to allow the spa to drain by gravity through the drainage hose
incorporated into the spa (see paragraph 3.6), use an extension hose if necessary.
38/64
2021/02 - Indice de révision : E - Code : 37791
BIEN-ÊTRE
Publicité
Chapitres
Table des Matières
